Co-authored-by: Ryan <fauxpark@gmail.com>
Co-authored-by: Sergey Vlasov <sigprof@gmail.com>
Co-authored-by: Joel Challis <git@zvecr.com>
Co-authored-by: Nick Brassel <nick@tzarc.org>
Python will evaluate first the left and then the right side of the and operator.
The left side would previously return True based on the truthiness logic that treats any non-emptry string as true.
It would not check if the desired keymap exists.
If the left side is true it will evaluate the right side which will check for the existance of a specific keymap.
With this change the check for existance of two keymaps is implemented.
* Tentative Teensy 3.5 support
* Set firmware format to .hex for ARM Teensys
* Got to "device descriptor failed" by comparing with Teensy 3.6 code
* Drop down to 96MHz...
* Bump back up to 120MHz
* Disable RESET keycode because of naming conflicts
* Add Pico SDK as submodule
* Add RP2040 build support to QMK
* Adjust USB endpoint structs for RP2040
* Add RP2040 bootloader and double-tap reset routine
* Add generic and pro micro RP2040 boards
* Add RP2040 onekey keyboard
* Add WS2812 PIO DMA enabled driver and documentation
Supports regular and open-drain output configuration. RP2040 GPIOs are
sadly not 5V tolerant, so this is a bit use-less or needs extra hardware
or you take the risk to fry your hardware.
* Adjust SIO Driver for RP2040
* Adjust I2C Driver for RP2040
* Adjust SPI Driver for RP2040
* Add PIO serial driver and documentation
* Add general RP2040 documentation
* Apply suggestions from code review
Co-authored-by: Nick Brassel <nick@tzarc.org>
Co-authored-by: Nick Brassel <nick@tzarc.org>
Ryan
Nick Brassel
Joel Challis
Drashna Jaelre
Sergey Vlasov
Erovia
Albert Y
Niko Wenselowski
Dasky
Stefan Kerkmann
precondition