qmk_firmware/docs/power.txt

Time to Sleep
=============
USB suspend     no activity on USB line for  3ms
No Interaction  no user interaction
    matrix has no change
    matrix has no switch on


AVR Power Management
====================

V-USB suspend
    USB suspend
    http://vusb.wikidot.com/examples

MCUSR   MCU Status Register
    WDRF    Watchdog Reset Flag
    BORF
    EXTRF
    PORF    Power-on Reset Flag

SMCR    Sleep Mode Control Register
    SE      Sleep Enable
    SM2:0
        #define set_sleep_mode(mode) \
        #define SLEEP_MODE_IDLE         (0)
        #define SLEEP_MODE_ADC          _BV(SM0)
        #define SLEEP_MODE_PWR_DOWN     _BV(SM1)
        #define SLEEP_MODE_PWR_SAVE     (_BV(SM0) | _BV(SM1))
        #define SLEEP_MODE_STANDBY      (_BV(SM1) | _BV(SM2))
        #define SLEEP_MODE_EXT_STANDBY  (_BV(SM0) | _BV(SM1) | _BV(SM2))


ACSR    Analog Comparator Control and Status Register
    To disable Analog Comparator
    ACSR = 0x80;
    or
    ACSR &= ~_BV(ACIE);
    ACSR |= _BV(ACD);

    ACD: Analog Comparator Disable
        When this bit is written logic one, the power to the Analog Comparator is
        switched off. This bit can be set at any time to turn off the Analog
        Comparator. This will reduce power consumption in Active and Idle mode.
        When changing the ACD bit, the Analog Comparator Interrupt must be disabled
        by clearing the ACIE bit in ACSR. Otherwise an interrupt can occur when
        the bit is changed.

DIDR1   Digital Input Disable Register 1
    AIN1D
    AIN0D
        When this bit is written logic one, the digital input buffer on the AIN1/0 pin is disabled. The corresponding PIN Register bit will always read as zero when this bit is set. When an analog signal is applied to the AIN1/0 pin and the digital input from this pin is not needed, this bit should be written logic one to reduce power consumption in the digital input buffer.


PRR     Power Reduction Register
    PRTWI
    PRTIM2
    PRTIM0
    PRTIM1
    PRSPI
    PRUSART0
    PRADC